$645CDN

The Pro Jack 3500 is an economical sliding jack that makes any four post lift complete. This versatile jack requires no air or electricity. It operates by the hydraulic hand pump, and is adjustable to fit most four-post lifts.

3,500 LB. capacity Manually operated Scissor mechanism allows for level lifting Compact size with a low profile Adjustable width fits most four post lifts Safety lock positions Adapters included Powder coated finish Smooth rolling action Adapter storage Capacity 3,500 LB. Maximum Width 41 1/2" Minimum Width 29 1/2" Minimum Width with Arms In 38 3/4" Maximum Width with Arms Out 61 1/2" Minimum Height with Lift Pad 3 1/2" Lifting Pad 1 3/8" Short Adapter 1 1/4" Tall Adapter 5" Raised Height without Adapter 11" Raised Height with Small Adapter 12 1/4" Raised Height with Large Adapter 16" Raised Height with Sm. & Lg. Adapter 17 1/4" Shipping Weight 350 LB. Picture Below shows TWO Pro Jack 3500s The Direct Lift Pro Jack 3500 (3500 LB. capacity) sliding hydraulic vehicle jack is a great choice for the owner of the Direct Lift ProPark7. The Direct Lift Pro Jack 3500 will also fit the Direct Lift ProPark 9. The Direct Lift Pro Jack 3500 is for those who want to perform wheel service on a vehicle that is positioned on top of their four post lift. The complete Direct Lift ProPark 7 four post lift comes with a jack tray. The jack tray has certain limitations that are eliminated by using the Direct Lift Pro Jack 3500. The jack tray (with a small floor jack or jack stands) will support ONLY THOSE LIFTING POINTS of the raised vehicle that are between the runways of the Direct Lift ProPark 7 four post lift. The Direct Lift Pro Jack 3500 has telescoping arms that can be extended over the runways of the four post lift. The lift pads at the end of these arms can be positioned under the LIFTING POINTS (that are located over the runways of the four post lift) of the vehicle allowing the operator to access many more LIFTING POINTS than just using the jack tray. The Direct Lift Pro Jack 3500 comes standard with a set of peg style truck adaptors which increase the lifting height of the lift pads. These truck adapters will allow the Direct Lift Pro Jack 3500 sliding hydraulic jack to raise pick up trucks that will sit higher on the runways than the average passenger car. The Direct Lift Pro Jack 3500 is operated by a manual hydraulic pump (porta-power pump) and does not require an air compressor for power. The Direct Lift Pro Jack 3500 sliding hydraulic jack also features two solid locking positions that are used when the vehicle is to be suspended above the runways. When the locking positions of the Direct Lift Pro Jack 3500 are engaged, the hydraulic pressure from the lifting cylinder of the Pro Jack 3500 is eliminated. (These locks act much like a pair of jack stands after you lift a vehicle off the ground with a service jack).